Optilock

    Filter

      Optilock is Sako's own mounting system, made for Sako and Tikka rifles — blued steel bases for short and long actions, rings in 30mm and 1in from low to high, plus Weaver and Picatinny base units and replacement screws.

      Why the factory system

      Optilock rings use a polymer insert between the ring and the scope tube. It grips without marking the tube and takes up the small alignment errors that otherwise put a bending load through the scope body — which is the usual cause of a scope that will not hold zero despite everything looking tight.

      Ordering the right parts

      You need two things: the base pair that matches your action, and the rings that match your scope tube and objective. Sako actions are grouped by length — short action 1 and 3, long action 4 and 5 — and the bases are not interchangeable between them, so check which action your rifle is built on before ordering. Tikka rifles take their own dedicated bases.

      For ring height, mount as low as the objective bell will allow so your cheek sits naturally on the comb. Most 40–44mm objectives clear in lows or mediums; 50mm and above generally need highs.

      The Torx T10 ring screws and ring-to-base screws are listed separately — useful, because these are small parts that go missing on a kitchen table and are not worth a whole new mount.

      Related: Scope mounting · Warne mounts · Sako

      22 products